Thursday, January 20, 2011

Re: [MW:9347] RE: 9343] THICKNESS LOSS IN UNSO6625

Dear Mr.Bazrafshan
thank you for reply.
but in mentioned list, there is not suitable document.
regards

On Thu, Jan 20, 2011 at 11:30 AM, Bazrafshan,kazem <KBazrafshan@bpc.co.ir> wrote:

Dear Sir:

Please see referenced documents(Clause 2) in ASTM B564,I think these referenced STDs may be useful.

 

Regards

Bazrafshan

 

From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of Ali Asghari
Sent: Thursday, January 20, 2011 9:16 AM
To: materials-welding@googlegroups.com
Subject: [MW:9343] THICKNESS LOSS IN UNSO6625

 

Dear All

in some cases in UNS06625 fittings, alittle thickness reduced by grinding, now in which section of ASTM  i find the acceptance criteria of thickness loss?(i don't find in ASTM B564)

REGARDS

 

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...