Thanks for ur feedback
Rgds
AW
From: Suresh <bobsuresh24@gmail.com>
Sender: materials-welding@googlegroups.com
Date: Fri, 21 Jan 2011 19:47:24 +0530
To: <materials-welding@googlegroups.com>
ReplyTo: materials-welding@googlegroups.com
Subject: Re: [MW:9385] Hardness of SA516 all grade
Hii ,
As per the specification SA 516 Grade 60/70 Hardness values are not specified. For welded coupons, the values are normally specified in the buyers specifications. In most of the cases it is specified 250 as a maximum value (specified by the end users specification data). You may check up with your clients specifications for the requirements....
Regards
Suresh
On Fri, Jan 21, 2011 at 4:36 PM, <adwenda@gmail.com> wrote:
Dear experts,
Please advise the hardness value of SA516 for all grade (with ref. detail) since it is not mentioned either in ASME sect. II/IX or the correspond ASTM.
Even we can take the figure from conversion table or theoretical formula, I'm not confidence of using this as reference.
Appreciate for your feedback on this
Thanks and Rgds
A.D. Wenda - Indonesia
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
--
Thanks & Best Regards,
Suresh
Mobile No: 91-92 92 905 905
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
No comments:
Post a Comment